Brocade Router monitoring plugin

Verax NMS Brocade Router management plugin allows easy monitoring, alerting, health check, management and performance reporting of Brocade's NetIron series routers. SNMP is used for communicating with the hardware.

General information view

Verax NMS: Brocade Router management plugin (general information view)

The view presents general configuration information about a Brocade router such as: name, model, firmware version, MAC address and uptime.

IP routing view

The view presents the IP routing table including: IP addresses, masks, next hops, destinations, interfaces and others.

IP addresses view

The view provides detailed insight into IP addresses configured on router's interfaces.

Power supply view

The view provides detailed information about power supply configuration and output.

Fan state view

The view provides detailed information installed fans status (on/off).

MPLS LSP and hop table views

The views provide detailed Label Switched Paths (LSP) information for the MPLS router including: states, numbers of transitions, source IPs, destination IPs and active paths.

Predefined Brocade router monitoring templates

The plugin provides predefined templates for most commonly monitored Brocade router items (listed in the table below). Other, user-defined sensors and performance counters can be added.

Brocade Router monitoring templates
Brocade Router CPU utilization
Brocade Router Dynamic memory utilization
Brocade Router Management CPU utilization

See also

Cisco Router monitoring and management plugin »

Juniper Router monitoring and management plugin »

Generic Router monitoring and management plugin »